The 5mm Photodiode LED IR Receiver is a through-hole infrared photodiode (a light-sensitive diode that generates current when it detects infrared light) in a standard 5mm black body. The 5mm ir photodiode has a reverse voltage rating of 5V and a power dissipation of 100mW. The black body (tinted epoxy) blocks most visible ambient light so the diode responds primarily to infrared wavelengths.
The ir receiver led arduino connects in reverse bias (reverse polarity) across a resistor in a simple voltage divider circuit. One non-obvious detail — the photodiode generates only microamperes of current per unit of light. A transimpedance amplifier (an op-amp circuit that converts current to voltage) is often needed for clean signal output. The honest limitation is sensitivity to sunlight, which also contains infrared. The ir receiver led sensor works with Arduino and ESP32 analog or digital GPIO pins. To start, reverse bias the diode, add a pull-up resistor, and read the output. StemVolt provide electronics component tested for consistent infrared response.
Related Products:
- Check out 3 mm IR Transmitter and Receiver Pair
Features:
- Reverse voltage rating at 5V matches standard Arduino and microcontroller circuit voltage levels
- 5mm through-hole body diameter fits standard breadboard holes and through-hole PCB footprints
- Black epoxy body absorbs visible light wavelengths improving selectivity for infrared detection
- ir led 5mm infrared receiver body size allows direct pairing with standard 5mm IR LED transmitters
Technical specifications:
| Specification | Details |
|---|---|
| Component Type | IR Photodiode Receiver |
| Diameter | 5mm |
| Reverse Voltage | 5V |
| Power Dissipation Pd | 100mW |
| Color | Black |
Applications:
- Line follower robot uses this photodiode to detect reflected IR light from a white surface
- 5mm Photodiode LED IR Receiver reads IR remote control signals for a custom Arduino decoder circuit
- ir receiver led sensor reads reflected infrared from a surface to detect presence at close range
- Flame detector project reads infrared emission from a candle flame and triggers a GPIO alarm output
Package includes:
- 1 x 5mm Photodiode LED IR Receiver


















Reviews
Clear filtersThere are no reviews yet.